Undergraduate
Essay
Engineering and Construction
Pages 1 (251 words)
Download 0
This is because the slope is gently lying and not steep. The elevation of the existing slope in this area is about 20 meters at an angle of approximately 31o. With reference to the drawings of this area, a single…

Introduction

Therefore, the results obtained indicate that it is safe to work on the slope and the slope suits its desired needs. This is because there are no signs of possible ground movements and the rock structure seems to be solid and not fractured. Nevertheless, an investigation on possible ways in which ground movements may occur within the area is essential (Eberhardt 2003).
However, it is highly recommended that adherence to the design be ensured so that excavation on the slope does not yield negative impacts. This is because failure to do so would result in ground movements, which may impact the normal functionality of the slope that includes ground movements that jeopardize people’s safety. In addition, further analysis needs to be done through the use of slope stability software, which aids in searching for the critical slip ...
Download paper
Not exactly what you need?

Related papers

Community Involvement in Construction
The involvement of the community benefits both the community and the economy. The research is made to enhance the economy and to attain advantages from the community. Different books, literary articles in different magazines, newspaper and journals are utilized for the collection of data and information (Groat & Wang, 2002). However, interviews and questionnaire were also adopted for the…
conclusion
Therefore, the results obtained indicate that it is safe to work on the slope and the slope suits its desired needs. This is because there are no signs of possible ground movements and the rock structure seems to be solid and not fractured. Nevertheless, an investigation on possible ways in which ground movements may occur within the area is essential (Eberhardt 2003).…
lab report
Further, the overall RPM range for the AC motor was approximately 1/3 that of the rpm range for the DC motor. Likewise, the AC motor was ultimately providing the power and driving the DC motor. Lastly, the AC motors in synchronous speed decrease was tangentially related to the decrease in AC motor drive frequency.…
Torsion test
The shear magnitude of the two pieces were established as
paraphrasing
Moreover, this lab experiment made it possible to design and create center-tapped transformer and full-wave bridge rectifier circuit and examine their waveforms as well as give explanation for them. It was not easy to realize how to get the waveform of the second circuit, however the task was implemented. In general, this lab experience was done effectively for both circuit designs.…
Paraphrasing#3
In circuit four, current through resistors R1 and R5 was the same because they were connected in parallel.…
applied thermodynamics
The agency is doing a very good job in conserving the environment. It is agreeable that global warming is an impending danger to the world. However, it is not quite sensible to consider dictating to countries on how to manage the environment, especially if major economic resources are concerned. By this, countries that depend on coal as the main source of energy may require to take a lot of time…