Equipment Specification: FX series Forced Air Oven - Essay Example

Check the temperature every hour until the reading is not changing anymore and compare the reading of the digital display with that of the reference thermometer. If there is a considerable difference between the two readings, but the display into ‘calibration mode’ by pressing both UP and DOWN arrow keys simultaneously until the display starts to flash. Adjust the temperature using the UP and DOWN arrow keys while flashing. Allow the oven temperature to stabilize and recalibrate if necessary.

When the oven is stable at the desired setpoint (see 3 and 4 above), turn the Safety Thermostat counterclockwise till the OTP light turns “ON” and then turn the Safety Thermostat clockwise just until the OTP light turns ‘OFF”. Next, turn the thermostat clockwise two smallest divisions of the scale past the point where the lights went out to set the Safety Thermostat at a temperature approximately 100C above Main Temperature SetPoint.Ten-minute function – Push RESET pad.

 Keep a certified reference thermometer inside the oven chamber or through the access tube at the top left. Make sure the thermostat is not in contact with the shelves. Check the temperature every hour until the reading is not changing anymore and compare the reading of the digital display with that of the reference thermometer. If there is a considerable difference between the two readings, but the display into ‘calibration mode’ by pressing both UP and DOWN arrow keys simultaneously until the display starts to flash.

Adjust the temperature using the UP and DOWN arrow keys while flashing. Allow the oven temperature to stabilize and recalibrate if necessary.[Note: Check temperature accuracy in monthly intervals]6. Set Over-Temperature Safety thermostat:When the oven is stable at the desired setpoint (see 3 and 4 above), turn the Safety Thermostat counterclockwise till the OTP light turns “ON” and then turn the Safety Thermostat clockwise just until the OTP light turns ‘OFF”. Next, turn the thermostat clockwise two smallest divisions of the scale past the point where the lights went out to set the Safety Thermostat at a temperature approximately 100C above Main Temperature SetPoint.