Free

Estimating the Height of a Building - Assignment Example

Summary

The writer of this paper states that there are many methods of estimating the height of a certain building. However, this paper will estimate the height of the Shrine’s bell tower at the location indicated by the arrow by counting the number of floors and then multiplying this by 15ft. …

Download full paper File format: .doc, available for editing

GRAB THE BEST PAPER97.9% of users find it useful

Read Text Preview

Subject: Engineering and Construction
Type: Assignment
Level: Masters
Pages: 1 (250 words)
Downloads: 0
Author: kasey87

Extract of sample "Estimating the Height of a Building"

Therefore, the calculation of the height of the building will be as follows;15 * 7 = 108This means that the height of the tower from the first floor is 108ft. However, in order to find the total height of the building from the ground floor, 15ft have to be added to the total 108ft. Therefore, the total estimated height of the tower from the ground floor to the indicated place will be 123ft.108 + 15 = 123ftThis estimation method is better since there is no information provided about the height of the floors.

Even though the estimation method cannot provide accurate data, it is the best method for estimating the length of the tower up to the indicated place. Question 2In order to calculate the total load the foundation of the tower must carry, assumptions have to be made based on the universal measurements used for the construction of towers and buildings. One can assume that the tower is 8m wide and 16m long, the wall, that is above the foundation, is 1.0kN/ m, the piers are 300mm, and the walls are 200mm thick.

The mass of the concrete used in the construction is 2400kg/m3. Below is the calculation for each floor which will later be multiplied by the number of floors present in the tower.Wall load – for each side16 x 1.0kN16kNFoundation load –for each side, 16 x 24kN x 0.276.8kNFloor load - for each side 7/32 x 998kN218.4kNFloor load - 1/8 x 998kN124.8kNTotal 324kNFrom the calculations above, the total amount of load on the foundation is equaled to 324 * 10 = 3240kN. Factor 10 has been used since it is the number of floors that are evident in the image provided.

The result obtained is a rough estimate since there are no accurate data provided by the image.

CHECK THESE SAMPLES OF Estimating the Height of a Building

Airline computer application

In due course they invested into research and development of the particular invention to make it more users friendly and easier and nearly in 1970 airlines were successful in building up their own systems.... Reservations and the internet Among the various airline computer applications the computer reservation system holds much importance in today's date....

7 Pages (1750 words) Essay

Cost Estimation Plans for Sydney Harbour Tunnel

This paper is about cost estimation plans for Sydney harbour Tunnel.... After giving a brief introduction of the tunnel, various approaches and perspectives for cost estimations of huge infrastructure projects are given.... The tunnel proved to b less than a success and there were a number of hindering factors which are responsible for the failure of the project which is also considered as an important Public Private Partnership (PPP)....

10 Pages (2500 words) Coursework

Applications of Environmental Valuation for Determining Costs

The authors of the following article claim that in order to assess the effectiveness of the measures taken to control the environmental impact it becomes important that the costs and benefits of such measures are reduced to dollar terms so that a comparison is made possible.... hellip; The article casts light upon the fact that the process of ascertaining the monetary value of the effect of regulatory and other measures is often found to be complicated and uncertain....

6 Pages (1500 words) Article

Total Load Exerted by the Bell Tower

The Shrines bell tower is located at the 8th story and therefore the approximate height of the Bell tower can be Other (s) Estimating Problem There are a number of methods that can be used to estimate the height of Bells tower as shown in Figure 1.... Lastly the height of the Bell can also be estimated using simple Trigonometry.... Using a position with a known distance from the Shrine building, the height of the location of the Shrines tower can be calculated as Height=Tan (Angle) x the known distance....

1 Pages (250 words) Essay

Construction Management

The paper "Construction Management" discusses that large loaders use a hydraulically actuated point that is set between the rear and the front axle, unlike tractors and backhoes that use automotive steering.... The mechanism enables the front load axle to be solid.... hellip; The backhoe pulls material towards them, thus they need the lowest radius for their effectiveness; hence minimum force and power is needed, unlike the front shovel which lifts with maximum radius....

8 Pages (2000 words) Coursework

The Different Design Treatments

Such a situation gives the base figure in the building valuations.... However, there are cases where their application needs to be adjusted as defined from the building Elemental Costs.... There is a need to note that costing estimation figures are provided for a typical building which is the one in this evaluation.... High standard have individual facilities, roads, parking, and full services Plot ratio and Site cover: This measures up to 1107m2 and comprises a Superstructure where the building structure above floor level....

10 Pages (2500 words) Assignment

Estimation of Available Safe Escape Time

2013, 223-228)Where H is the height of the enclosure (m), Af is the area of the floor (m2), pg is the density of the upper layer (kg.... Thus, ASET should be long enough to enable the occupants in a building to evacuate to a safe place before the end of ASET.... The building design is considered to be safe if ASET is greater RSET.... It can be increased by ensuring that the building is made of less flammable building materials and installation of fire control system to control fire and smoke....

5 Pages (1250 words) Assignment

Winds On Building

This report "Winds On building" sheds some light on the various effects of wind loads on buildings.... After this terrain, there is a layer that acts as a boundary layer where the speed of the wind varies from very low speeds to a gradient wind speed at a gradient height....

8 Pages (2000 words) Report