Both simulation and laboratory procedures produced results consistent with expectations with empirical confirmation of the theory of the electrical behavior of RC networks as developed in the experiment. Further, the correctness of the development is confirmed considering that it agrees with the preceding experiment even though there were slight deviations. The results thereby were successfully used to establish how change in resistance, capacitance, and charge affected the charge of the capacitor over time. When the charge was increased to 20, the charge of the capacitor slowly discharged over the course of the simulation, but converged on a value around 16 rather than descending all the way to 0. When capacitance was changed to 20, the charge of the capacitor very lowly descended until it actually attained a negative charge. When the resistance was increased to 30, the charge of the capacitor dropped to below 0 very quickly. Further, the simulation also showed that the relationship between current and capacitor is such that when capacitor is fully charged the flow of any electrons is blocked thereby no change is observed in current at that point. The possible sources of error for the deviations can be attributed to experimental error especially for the simple mistakes in positioning the oscilloscope cursor. Other possible source is deviations observed in input-offset voltage and the input-bias
In this lab, the major objective was to simulate a RC circuit that could allow us to measure the current and voltage across the resistor and capacitor. Meeting the above objective provided a platform for exploring how charge on capacitor changes with time when different…
When the material is pulled, one would be able to establish the strength of the material. In this regard, tensile testing can help one to develop an insight into various substances. Whenever one continues to pull on a material, the material will break hence one would get a recommendable profile of tensile.
3. Add 1 ml of starch indicator and 0.05 ml of 0.1 M EDTA solution from the Chemical Shelf to the same 250 ml beaker. This drop of EDTA solution is to minimize the effects of trace quantities of metal ion impurities that would cause spurious effects on the reaction.
1. E. coli is in competition with S. euglensis at a temperature of 20-35 degrees and a pH of 6-7.5. E. coli is also in competition with N. atol at a temperature of 20-30 degrees and a pH of 4.5 -6.5. P.
Another related objective was to apply equations for basic projectile motion in determining how high a rocket can fly. Since launching the model rocket, this is considered a projectile motion influenced by height of launch pad,
In which case, the slope of the position time graph was compared against the average velocity obtained from the velocity time graph.
From the results attached, the slopes found in the position versus time graphs are reasonably close to the average velocities with
o calibrate the pressure transducer and then perform an uncertainty analysis and compare your pressure transducer calibration to the manufacturer’s calibration.
1. Excite the pressure transducer, with a voltage of 10v. The figure above had J17 and J18 as AO (Analog Out). It
A lower value of the dipole moment will reduce the magnetic field while a high value will result into a larger magnetic field on the simulation.
The simulation agreed totally with the expected results from
1 pages (250 words)Lab Report
Hire a pro to write a paper under your requirements!
Win a special DISCOUNT!
Put in your e-mail and click the button with your lucky finger
Apply my DISCOUNT
Got a tricky question? Receive an answer from students like you!Try us!
Let us find you an essay for FREE
Contact us via Live Chat, call us at +16312120006or send an email to firstname.lastname@example.org