CCNA Basic (Final Assignment) - Essay Example

4. Define redistribution filters, if desired. 5. Enable redistribution, if you defined redistribution filters. 6. Modify default global and port parameters as required. 7. Modify OSPF standard compliance, if desiredTo enable OSPF enter enable ospf and respond to the prompts: OSPF Config>enable ospfEstimated # external routes[0] 200Estimated # OSPF routers [0] 60OSPF Config>set areaArea number [0.0.0.0] 0.0.0.0Authentication Type (0:NONE, 1:SIMPLE, 2:CRYPTOGRAPHIC) [0] 1Is this a stub area [No]: OSPF Config>set interfaceInterface IP address [0.0.0.0] 172.16.100.030Attaches to area [0.0.0.0] 0.0.0.0Retransmission Interval (in seconds) [5]Transmission Delay (in seconds) [1]Router Priority [1]Hello Interval (in seconds) [10]Dead Router Interval (in seconds) [40]Type Of Service 0 cost [1] 5Authentication KeyRetype Auth.

KeyMessage Digest Key ID [0]MD5 KeyRetype MD5 KeyOverride the default OSPF interface-type [No]: yOSPF interface-type override(1=broadcast, 3=NBMA, 5=point-to-multipoint) [0] 3Poll Interval [120]Forward multicast datagrams [Yes]:Forward as data-link unicasts [No]:OSPF Config>set virtual-linkVirtual endpoint (Router ID) [0.0.0.0] 10.10.10.1Link's transit area [0.0.0.1]Retransmission Interval (in seconds) [10]Transmission Delay (in seconds) [5]Hello Interval (in seconds) [30]Dead Router Interval (in seconds) [180]Authentication KeyMessage Digest Key ID [0]Message Digest KeyRetype Message Digest Key(c) Configure manual summarization for 10.201.1.

0/24, on serial 2, using EIGRP - using an example of one default routehostname branch1!interface Serial2ip address 10.201.1.0 255.255.255.0.router eigrp 10 redistribute static metric 56 100 255 1 255 network 10.201.0.0!ip classlessip route 0.0.0.0 0.0.0.0. This will allow you to have 32 subnets (25). After using the five bits for subnetting, you are left with 11 bits for host addresses. Therefore, this will allow each subnet to have 2048 host addresses (211), 2046 of which could be assigned to devices. (d) Configure DHCP using a pool called 'ISP' containing 10.10.0.0/16. Include the default gateway of 10.10.0.

01 and a DNS server at 10.10.0.5. Exclude the range of IP address from 10.10.0.1 to 10.10.0.15 Edit the /etc/dhcpd.conf file to configure DHCP service. In our setup, the server has IP address 10.0.0.1 and provides IP addresses up to 253 clients. Configure /etc/dhcpd.conf according to your environment: